- 100% 304 stainless steel construction
- Thick 3/8″ flange
- Factory weld-on center support for a solid mounted intake
- Dyno tested
- street proven for superior drivability and reliability.
Built to last made in the USA!
Overall width is made to fit 1600cc to 2387cc engines
CARB:
Clocks flange so the throttle is perpendicular to the car on the rear side, throttle pulls to the right if facing the engine bay.
EFI:
Clocks flange front to back parallel with the car so throttle is on driver side pulling front to back
All 4 barrel MAX Intakes have a 2.5" center T section which reduces to 2" ends for MAX flow! This intake is designs for the 400hp + engines or large NA engine spinning north of 8k rpms.
The intake will mount to stock location with some modification trimming the alternator stand. Will fit the High flow CB end castings (2" coupler) or Other custom intake end castings. Shortening of the ends may be required depending on engine width and intake castings used
Comes complete with following hardware:
4 x 8mm bolts
4 x 8mm nuts
2 x 2" Silicone couplers
4 x T bolt clamps
1 x Flange gasket
Read More